automotive fold down seat carpet installation::Trimming for that perfect fit into your car automotive fold down seat carpet installation

automotive fold down seat carpet installation

automotive fold down seat carpet installation

automotive fold down seat carpet installation::Trimming for that perfect fit into your car.
You will need a good pair of scissors and a razor knife.
Use extreme caution when placing the screws through loop weave carpet, the loop tends to grip the screw and will pull out in a continuous line of tuffs.
Please take your time!
Your molded carpet has been custom molded to fit your vehicle.
Plan to leave enough time for the disassembly of your interior, removal of the old carpet, proper installation and reassembly of your interior.
Remove your new molded carpet from the box, unroll and lay the carpet in a warm area and allow it to settle for one to two hours before attempting to install.
Be sure to keep the screws.
Remove rear seat cushions and center console if applicable.
Remove seat belt bolts if they are mounted in the carpet area.
Remove the old carpet.
Remove the old carpet, keep it!
Do not discard the old carpet yet.
Vacuum or sweep the floor, remove all loose matter.
Place the old carpet over your new molded carpet.
Mark any holes or additional cutout on the carpet with chalk, do not cut yet!
After confirming the proper fit, start the required cutouts as you fit the carpet to the vehicle.
Do not over cut!
After the correct fit is determined, fold back a section of carpet, apply adhesive, and press back down to the floor.
Replace back seat, kick panels, consoles, seat belts, front seats, and sill plates carpet.